In order to prolong the life of your Spa and ensure good running order we recommended that it has a regular service

CALL US TODAY FOR MORE INFORMATION

01268 816200 – 07984 857974

Spa Wars Deep Clean & Service

From only £299* plus parts, our skilled engineers will help you to ensure that your swim spa or hot tub is kept in good working order. If you are moving we can give you the required help with re-locating or disposing of your Spa.

Hot Tub Deep Clean

  • A chemical treatment will be used to flush the entire system. This will remove any dirt and stagnant water build up from within your Hot Tubs pipework and pumps.
  • Your filters will be thoroughly cleaned with a cleaning solution. If filters are not in a cleanable state, they will need to be replaced. This will be determined by your engineer and charged at an addition once agreed with the customer.
  • The Hot Tub will be fully drained and vacuumed to ensure that all water residue is removed.
  • The surface of the Hot Tub will be thoroughly cleaned, removing all Jets and Pillows and inspecting each part. Each Jet and Pillow will be cleaned individually. The removal of these parts is determined by your Hot Tub model and make. Some Hot Tubs do not have these parts as easily accessible.


Hot Tub Service

  • All components will be inspected including pumps, blowers, heater etc. These will be checked to ensure they are in full working order. Parts that may need replacing and not covered by a manufacturer’s warranty are determined by your engineer and charged at an addition once agreed with the customer.
  • If applicable, the ozonator in your Hot Tub will be inspected and descaled.
  • A full inspection for leaks will be performed. This includes the analysis of all pipe work to ensure a full seal is intact and all pipe work is correctly joined. This will not be performed on models which are fully foam insulated due to the nature of the work that is required on these models.
  • All unions within the Hot Tub will be tightened and inspected. Seals will be replaced if seen as necessary by your Hot Tub engineer.
  • Your Hot Tub will then be refilled with fresh water after your service. Once full, all pumps will be primed and inspected for air locks.
  • Using your own chemicals, the water will be tested and the required dosage will be added. If required, our engineer will be able to supply you with new chemicals at an additional cost.
  • The Hot Tub lid will then be inspected and cleaned using the appropriate chemicals.
  • Once the service has been concluded, our engineer will advise you of any issues detected and further instruction regarding the maintenance of your Hot Tub.

This full Package is provided to you at a cost of £299.00

 

 Full Hot Tub Service – £299

    • Spa Flush (cleans out pipework from bacteria and debris)
    • Drain down
    • Wet vacuum out
    • Full shell interior clean
    • Full cabinet clean (silicone shine protector if plastic)
    • Full lid clean and cover protector.
    • Filter soak
    • Water balance
    • 26-point check, Inc. unions, cabinet, leaks, pumps, pump shafts, jets, heater, control box.
    • Visual healthcheck with report.

 
Full Swim Spa Service – £399

    • Spa Flush (cleans out pipe work from bacteria and debris)
    • Drain down
    • Wet vacuumed out
    • Full clean of inside of the spa
    • Full clean of cabinet (silicone shine protector if plastic)
    • Full lid clean and cover protector.
    • Filter soak
    • Water balance (depending on water pressure to fill)
    • 19 point check, includes union checks, internal cabinet checks for leaks and malfunctions, pump shaft check, visual jets check, control box check

 

Hot Tub Winter Shut Down – £199

Need to drain your spa down for the winter? Going away for a while? Take advantage of our Winter Shut Down service. By not draining the hot tub system fully and leaving stagnant water in the pipes there is serious risk of damage to your spa, which could result in costly repairs.

 

    • Pipework Flush
    • Filter soak
    • Full Drain down including pipework
    • Internal clean
    • Winter wrap

 

 Refresh Hot Tub Service – £199

    • Drain down
    • Wet vacuum out
    • Full shell interior clean
    • Full cabinet clean (silicone shine protector if plastic)
    • Filter clean / replace
    • Fresh water refill
    • Pump check
    • Visual healthcheck with report

See the drop-down lists below for full Hot Tub Service details

26 point Spa Service Plan
  1. Water analysis

    Test the current sanitizer and pH levels in the spa water.

  2. Water treatment recommendations
    Based on water analysis and condition of water recommend changes to care routine or products required to keep hot tub in good condition
  3. Visual plumbing check

    Check plumbing including pipe/heater unions and isolation valve connections for integrity and identify if any leaks are present
  4. Test jet functions

    Check all jets for satisfactory operation. Ensure they all turn on and off, and free up any stuck ones if possible.

  5. Test topside diverter and air values (if fitted)

    Open all diverter and air values to ensure working correctly.

  6. Test ozone output (if fitted)

    Check ozone system and ozone jet are operating correctly, and advise if ozone unit needs changing
  7. Visual check of pump and heater seals
    Remove pump and heater unions and check seals
  8. Test all electrical components
    Test operation of all electrical equipment, and visually check all the interconnecting wiring for integrity and insulation
  9. Visually check circuit board

    Conduct visual check of circuit board and that it is operating correctly
  10. Test RCD & isolator (if fitted)
    
Perform a button test of the RCD if available and accessible. Test power input and output to isolator if available and accessible
  11. Complete bio film pipe clean

    Flush out the whole system with the industry leading pipe cleaner Swirl Away. This is a very strong biodegradable formula that gets deep into your hot tub system and helps remove dirt and scale build up
  12. Drain, rinse and wet vacuum spa and jets
    Drain water from the hot tub with a submersible pump. Rinse to clean, and wet vacuum remaining water and debris from spa and jets
  13. Clean and buff spa shell
    
Wipe clean spa shell with spa surface cleaner. Clean off scale and residue where possible
  14. Headrest condition report (if fitted)

    Thorough inspection of any headrests or pillows. Condition rating will be indicated on service report along with any recommendations and comments.


  15. Clean headrests (if fitted)
    
Remove headrests or pillows (where possible), rinse and clean with spa surface cleaner
  16. Filter condition report

    Thorough inspection of filter(s) and assessment of effectiveness. Filters are vital to the running of your hot tub and may need replacing if in poor condition. Condition rating will be indicated on service report along with any recommendations and comments
  17. Clean and refit filter(s)
    
Spray with filter cleaner and then clean between pleats using Super Blaster hose pipe attachment
  18. Clean outside of spa cabinet

    Wipe down and clean exterior spa cabinet
  19. Vacuum inside of cabinet (where access allows)
    
Remove panels, clean and vacuum service compartment and any other accessible areas
  20. Clean cover lifter (if fitted)

    Wipe and clean cover lifter
  21. Cover lifter condition report (if fitted)
    
Inspection of lifter mechanism to ensure safe and smooth operation. Condition rating will be indicated on service report along with any recommendations and comments
  22. Clean cover and treat with UV protection

    Clean cover and apply 303 protector for UV protection, and to help repel dust, soiling and staining
  23. Cover condition report
    
Inspect cover for fit, integrity, tears, water absorption and insulation properties. Also inspect cover clips (if fitted) and that cover can be securely clipped down. A poor fitting or damaged cover can affect the insulation of your hot tub. Condition rating will be indicated on service report along with any recommendations and comments
  24. Refill hot tub to correct level

    Refill with clean water to the required operating level
  25. Add sanitiser

    Add sanitiser to achieve a level of 2-4ppm (mg/l) Chlorine or 3-5ppm (mg/l) Bromine
  26. pH level balance

    Add pH+ or pH- to begin the correction of the pH level to attain a level of 7.2 to 7.4
Full service
  • Check the operation of all systems
  • Ampere pull, and overall check of all electrical components
  • Add a bio-film remover for your internal plumbing
  • Remove and chemically clean your filter
  • Add a shock dose to kill any bugs and nasties
  • Check the cabinet and shell for leaks, damage and condition
  • Check the condition of your cover and clips
  • Drain down your tub
  • Clean the acrylic surface
  • Remove any marks and stains where possible
  • Remove and clean the jets as much as possible
  • Ensure jets operate correctly
  • Rinse out your tub
  • Wet vac out any remaining debris and water
  • Towel dry the surface
  • Remove scale and debris from pumps
  • Check heater element and seals
  • Check pump union seals
  • Re-fill your tub
  • Bleed all pumps of air
  • Re-commission and check for leaks and correct operation
  • Balance the water using the customer’s choice chemicals
  • Check all systems ensuring they work correctly
  • Clean and treat the cover with vinyl protector
  • Re-check ampere pull of components
  • Reset filter cycles and time on control panel
  • Report any problems or advisories to the customer

Healthy refresh

  • Remove your filter and place in our cleaning solution
  • Add a bio-film remover for your internal plumbing
  • Shock dose to kill any bugs and nasties
  • Drain down your Hot tub and clean the acrylic shell
  • Rinse out the tub
  • Wet vac out any remaining debris and water
  • Re fill your tub
  • Re commission and check operation
  • Balance the water using the customers chemicals

Winter drain down

  • Remove and inspect your filter
  • Add a bio-film remover and shock dose for your internal plumbing
  • Soak your filter in our cleaning solution and clean
  • Check the operation of all systems and jets
  • Drain down your tub
  • Rinse out the tub
  • Vac out any remaining water and debris
  • Towel dry the acrylic surface
  • Rinse & dry store your filter
  • Drain water from all components inc heater
  • Loosen any screw fit joints
  • Clean and treat cover and replace
  • Plastic wrap lid if required
  • Isolate power supply so your spa can hibernate for the winter

Spring start up

  • Refit your filter or supply new at an extra cost
  • Rinse tub with fresh water
  • Re-connect all pipe work and heater element if applicable
  • Wet vac any water or debris
  • Re-fill your tub
  • Re-commission and check for leaks and correct operation
  • Balance the water using the customers chemicals
  • Check all systems ensuring they work correctly
  • Clean and treat the cover with vinyl protector
  • Reports any problems or advisories to the customer
  • Replace the cover

Please get in touch for a quote, visit our contact us page to email us

Call us today for more information

01268 816200 – 07984 857974

×

Hello and welcome to South East Hot Tubs

Click below to chat on WhatsApp or send us an email to chris@southeasthottubs.co.uk

×